Trigger Tuner

A one-minute test of trigger control. Each trigger has a target band that drifts up and down its travel, and you squeeze to keep your line inside it. Left and right move on their own, so each hand has to follow its own band. Keep both inside at once for a big bonus. As you play, the game counts how many different values each trigger reports, which shows how finely your controller reads them.

How to play

  1. Connect a controller with analog triggers over USB or Bluetooth.
  2. Press A (✕ on PlayStation, B on Nintendo) or Start, or click the button above.
  3. Squeeze the left trigger (LT, L2 or ZL) to move the left bar, and the right trigger (RT, R2 or ZR) for the right one. The bar turns green inside its band.
  4. Follow each band as it drifts. The scope beside each bar shows the last three seconds, so you can see where you strayed.
  5. The run lasts 60 seconds. The bands get narrower and move faster as it goes.
  6. Press Start to pause.

Scoring

Your results

When time’s up, the game shows for each trigger how much of the run it spent on target, how many different values it reported and how far it travelled.

Good to know

The bar jumps between empty and full

Some controllers, such as the Switch Pro Controller and Joy-Cons, have on/off triggers that are either released or fully pressed. The bands never reach the very top or bottom, so those triggers can’t score. The game tells you when it notices.

A trigger never quite reaches 100%

Some controllers stop a little short, and some have trigger stops that shorten the travel. Check what yours reports in the Gamepad Test.

The controller doesn’t rumble

Rumble works in Chrome and Edge with most Xbox and PlayStation controllers. Other browsers and controllers play the game the same way, just without vibration.

The buttons don’t match the screen

If the game says your controller has no standard layout, the browser doesn’t know its buttons, so the triggers can be numbered differently. Check it in the Gamepad Test.